Posted by Terry Hartzell on June 13, 2008 at 04:50:07 from (66.59.104.21):
As I have been working at fixing my Super A steering problem, I have run in to a problem that I would like to get some ideas on. First of all, it looks like my steering problem was caused by a combination of three things; a bad upper bearing, a worn key that holds the gear on the shaft, and a badly worn ball joint. I am at the point of reassembly where I've put the gear with key, the bearing retaining plate, the bearing, and the snap ring on the shaft. My problem is in trying to get the bearing up into the bearing seat. I am assuming that the bearing is to be forced up into the seat by means of tightening the bearing retainer bolts, otherwise, if you try to put the bearing in first and then put in the shaft you can't install the snap ring not to mention probably damaging the new bearing by driving the shaft up into it. Because you can't see the bearing with the gear and the bearing retaining plate in the way it is very difficult to get the bearing lined up on the seat. I have spent a lot of time on this with no success. What has been your experience, and what am I doing wrong? I would appreciate any suggestions, and I apologize for the long post.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Women and Tractors - More Views From the Farmer's Wife - by Teri Burkholder. The top ten reasons why the judges wouldn't let you participate in the stock antique tractor pull: Hey, this is stock! It came with that V8 in it! That "R" on my tires stands for "really old" not radial! Blue gas? We thought it was a pretty color! What wire hooked to my throttle?
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.