Posted by mkirsch on June 09, 2008 at 10:53:47 from (64.80.108.52):
In Reply to: Plow Bottoms posted by Chris450 on June 09, 2008 at 07:48:01:
Unless the plow frame is bent, any point on one bottom will be exactly the same distance away from the exact same point on the next bottom.
You can measure from the tip of the point to the tip of the next point, from landside to landside, from moldboard edge to moldboard edge, even from bolt to bolt. They'll be exactly 14" apart, measured straight across.
An easy way to do it is to take a framing square and lay it against the front bottom's landside so the L goes back and to the left, under the second bottom. You can read the measurement right off the square itself.
Just remember to read from the correct side of the square, or you'll end up thinking you have a 2" wider plow than you really do.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Box Plow Blues - by Tom Schwarz. One of the first implements most tractor owners obtain is the box plow. For very little money, this piece of equipment promises to plow and flatten any hill or vale on your ranch road or farm. At least that's what I thought! As simple as a box plow appears, it can be rather challenging to make work correctly. In our sandy soils of Florida, traction is king. You can never have wide enough tires or heavy enough weights to get all the traction you want … unless you own a monster tractor. U
... [Read Article]
Latest Ad:
Oliver 550 Diesel runs like a watch three point hitch pto engine gone threw about two hundred hours ago nice clean tractor
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.