Posted by Dave in Connecticut on June 05, 2008 at 09:39:29 from (69.182.133.248):
I'm finishing the assembly on a home-built three-point hitch for my '47 H. The design is pretty close to what Saginaw offers. I cut the holes for the front mount points of the lift arms to just accept the 3/4" pins. As such, the arms have no side-to-side play and the spread at the implement end of these lift arms is 22". I understand the standard spread is 26". I also only have holes at the implement end of these lift arms - not the ball socket ends. I'm hoping to avoid welding ball socket ends on the end of the lift arms for the time being. My questions are directed at getting the spread at the implement end of the lift arms to the 26" - 30" range that I'll need to hook up an implement.
Should I: 1) Drill the holes in the lift arms at the 3-pt frame end a little larger so they have some play to allow the spread at the implement end to go a little wider? I don't have any example 3-pt hitches nearby to check to see if this play is normal. 2) Put some bends in the lift arms to get the spread to the desired width? 3) Both
Eventually I will weld the ball sockets on the lift-arm ends but I was hoping to get this thing working by bush-hog time this weekend.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Tractor Profile: Allis-Chalmers Model G - by Staff. The first Allis-Chalmers Model G was produced in 1948 in Gasden, Alabama, and was designed for vegetable gardeners, small farms and landscape businesses. It is a small compact tractor that came with a complete line of implements especially tailored for its unique design. It featured a rear-mounted Continental N62 four-cylinder engine with a 2-3/8 x 3-1/2 inch bore and stroke. The rear-mounted engine provided traction for the rear wheels while at the same time gave the tractor operator a gre
... [Read Article]
Latest Ad:
Oliver 550 Diesel runs like a watch three point hitch pto engine gone threw about two hundred hours ago nice clean tractor
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
