on the farmalls, the hydraulic lever(s) work as such: (as seated driving the tractor)
centered is neutral/hold--the implement will stay where it is. push forward a little is momentary/feathered drop. to the first click forward is locked in drop. all the way forward is float--the implement will drop, also it can drop or raise further following ground contours without hydraulic resistance; a hydraulic motor would coast freely to a stop. back a little from the neutral/hold position is momentary/feathered raise, and all the way back is locked raise.
you should always hook up your lines so that forward is drop and back is raise, because if you accidentally put it in float the implement will immediately drop and cause a problem if you needed to raise in a panic situation. there is a float lockout, but i still prefer being in the habit of lift-back just in case.
also if you have a 3pt or fast hitch some manuals state that if it"s position/inner control lever is all the way to the bottom/forward of the quadrant the remote behavior will be slowed. if not using the 3pt/FH the draft/outer control lever should be all the way forward to HEAVY and the position/inner control lever should be all the way to the top or all the way lowered but not in the action control zone at the bottom--just before the offset in the quadrant.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Choosin, Mounting and Using a Bush Hog Type Mower - by Francis Robinson. Looking around at my new neighbors, most of whom are city raised and have recently acquired their first mini-farms of five to fifteen acres and also from reading questions ask at various discussion sites on the web it is frighteningly apparent that a great many guys (and a few gals) are learning by trial and error and mostly error how to use a very dangerous piece of farm equipment. It is also very apparent that these folks are getting a lot of very poor and often very dangerous advice fro
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.