Posted by Haas on May 28, 2008 at 18:53:21 from (12.65.42.185):
In Reply to: Super H rear end posted by Andrew Kappers on May 28, 2008 at 17:39:35:
I would not put any grease in the bearings or anywhere else in the rear end. That would be like sludge and would just hinder the flow of oil. If you put oil in the case before you put the top back on, you can spin the gears by hand and see how the lube system works. The gears throw oil up into the top channel that is at the top side of the case. The oil then drains along the channel and through passages that lube the bearings. If you want to prelube, just pour some oil in the channel after you complete the assembly and before putting the top back on. The proper oil level is to the level plug on the side of the case. Check your manual for location as I don't recall where it is on the H. Also, make sure the oil passages that go to the bearings are all open and not plugged with sludge. The Super H transmission I rebuilt a couple years back had those holes mostly plugged up with gunk, resulting in poor (or no) oil circulation and thus worn out bearings.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Box Plow Blues - by Tom Schwarz. One of the first implements most tractor owners obtain is the box plow. For very little money, this piece of equipment promises to plow and flatten any hill or vale on your ranch road or farm. At least that's what I thought! As simple as a box plow appears, it can be rather challenging to make work correctly. In our sandy soils of Florida, traction is king. You can never have wide enough tires or heavy enough weights to get all the traction you want … unless you own a monster tractor. U
... [Read Article]
Latest Ad:
Oliver 550 Diesel runs like a watch three point hitch pto engine gone threw about two hundred hours ago nice clean tractor
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.