Mark: Actually my experience with the W4 is quite limited, dad traded it off for an H when I was 9 years old.
My first expereience with the W4 was pulling hay wagon with loose hay loader behind. The two guys building the loads of hay from the hayloader were complaining about my aging grandfather being just a bit too vicious on the clutch. One day in 1948 dad said to me, "Hugh you've got a job driving the W4 loading hay as long as those two guys on the load don't complain." His offer was a bit hollow, I don't think I made quite two years until I graduated to being one of the guys on the load and my brother became the tractor driver. I also operated the W4 a bit on a spring tooth cultivator. Not until he got the H in 51 did I get a chance to do any plowing, same 2x14 plow.
In our soil dad claimed the H pulled the plow and other tillage implements better than the W4. that was eastern Canada with 45" annual rainfall where the soil was relatively soft. The 38" wheel definitely has an advantage in that situation. I believe if you go to the great western plains where flotation and traction were not a problem, the W series tractors had a distinct advantage, that being the smaller diameter wheel giving the same engine more torque and greater pulling power.
Most folks will think of the W series as a great plains tractor, and the Farmall for row crops of the mid west. However as early as 1951 we were asking for wider tires on Farmalls, hoping to gain more flotation on our soft soils. It was common to see an H or M on duals. Two things changed, tile drainage and wider tires by 1957.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Harvestin Hay: The Early Years (Part 2) - by Pat Browning. The summer of 1950 was the start of a new era in farming for our family. I was thirteen, and Kathy (my oldest sister) was seven. At this age, I believed tractor farming was the only way, hot stuff -- and given a chance I probably would have used the tractor, Dad's first, a 1936 Model "A" John Deere, to go bring in the cows! And I think Dad was ready for some automation too. And so it was that we acquired a good, used J. I. Case, wire tie hay baler. In addition to a person to drive th
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
