Posted by Randy-IA on May 03, 2008 at 21:25:48 from (207.177.83.138):
Hi All , To bring everyone up to speed I replaced every bearing , bushing and gasket from the input shaft back . I re-set the differential gears to zero side play and the backlash I only got to .012 . I did not check the contact pattern . I was going to and bought prussion blue marking compound but a seasoned mechanic told me that as long as I reinstalled the main shaft shims that came out then I shouldn't have to . Later when I told him about the noise he said I should have checked . That annoyed me some . So I thought the noise was from the differential . After dragging the hayrack around today picking up trees I cut down around the edge of the field yesterday and listening closely to the tranny I don't think it's coming from under the seat but actually from the tranny area . It idles quiet in neutral and runs a little quieter in high range than in direct . There's absolutely no noise coasting down a hill in gear with no load on the gears . So , with this information anybody have any suggestions as to what to check ? It might be a few weeks till I get around to working on it again . Thanks ! ...Randy
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - The Niagra View Mobile - Powered by a 1959 Ford Tractor - by Mark Massey. In 1959 the Niagara Frontier Transit Inc. of Buffalo, New York designed and built six Viewmobiles for the Niagara Frontier Sightseeing Inc. for use as a sightseeing ride at the Niagara Falls State Park, Niagara Falls, New York, powered by a 1959 Ford 611 Tractor.
... [Read Article]
Latest Ad:
Oliver 550 Diesel runs like a watch three point hitch pto engine gone threw about two hundred hours ago nice clean tractor
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
