Posted by bc on April 17, 2008 at 06:41:26 from (66.140.173.77):
Hi, been having brake issues as discussed on a thread some time back. Basically there was no adjustment left and I am using about an inch or more of washers to get the brakes to work. I had taken the left side off back then and found the discs were about new but still no adjustment. Talked to the cih parts guy and he indicated that the balls in the brake actuator plate assembly can wear down or maybe the plates can wallow out. He also suggested going from the 7/8" balls to one inchers.
Finally got to pull the right side last night (which also had to have about an inch worth of washers to make them work) and found about new disks and the actuating plates were almost touching. Calipered the balls and they were right on 7/8". They fit the holes about perfect but sat in fairly deep. Without replacing the actuator plate assembly which is probably expensive, I just wondering what anyone thinks about putting in bigger balls? Next time I get down to the parts dept I will try some 1 inchers he said he had in stock. thanks.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Choosin, Mounting and Using a Bush Hog Type Mower - by Francis Robinson. Looking around at my new neighbors, most of whom are city raised and have recently acquired their first mini-farms of five to fifteen acres and also from reading questions ask at various discussion sites on the web it is frighteningly apparent that a great many guys (and a few gals) are learning by trial and error and mostly error how to use a very dangerous piece of farm equipment. It is also very apparent that these folks are getting a lot of very poor and often very dangerous advice fro
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.