You're right. No dykes. A hacksaw is a poor idea too. You'd likely need a fine file to clean up the outside, a reamer to clean up the inside edge and have to remove the whole line to flush and blow out the filings.
What you need is a tubing cutter. You should be able to get the one you need at any good hardware, or even at Home Depot or Lowe's.
The big ones look like a C-clamp, with a couple of rollers on the fixed end that cradle one side of the tube, and a rolling cutting wheel on the threaded end that tightens against the side opposite the rollers. That gives you three points -- two rollers and a rolling cutting wheel -- to support and keep things in line. You thread the wheel so it just bites into the tube, give the whole thing a couple of turns around the tube, thread the cutting wheel in a little more, turn it a couple more times . . . Your first turns will score in just a shallow notch, but as you thread the cutting wheel in deeper the notch gets deeper and eventually cuts through.
Better for the small tube on this job, and for no more than you'd use it, they make a much smaller one that you could hide in your closed fist. Instead of looking so much like a C-clamp, it looks more like a small c-shaped cube, with a knob on the one side to thread in the cutting wheel. Works just the same as the big ones, and can be had for under or about ten bucks.
It avoids the need for other tools to clean up the cut and the pressure from the cutting wheel leaves just the slightest indentation on the end of the cut to make it easier to get the pieces of your compression fitting over the end of the line.
The link is to the assortment of such things at Sears, to improve on my questionable description of the gadget, and to give you an idea of the range of what's available.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Ford N-Series Transmission/Hydraulic Fluid - The Full Story - by Llamas. The transmission fluid in an “N”:-series tractor lubricates the transmission, differential, rear wheel bearings, PTO and hydraulic pump drive, and it also cats as the working fluid for the hydraulic lift. In 9N/2N models, it also lubricates the steering sector and shaft system. The owner’s manual for the 9N and 2N models specified the use of only two fluids. They were STRAIGHT MINERAL OIL SAE 90 (above freezing) and
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
