Posted by Daniel H. on April 09, 2008 at 19:30:28 from (66.226.34.159):
In Reply to: Re: Tie Rod Ends posted by tn terry t on April 09, 2008 at 16:45:13:
Try A&I products. You use the IH part number, but their prices are much cheaper. I try to buy from Case/IH when I can but, the long notched ones (360412R11)are around $45.00 from them and $210.00 from Case/IH. The short ones (356540R91) are $16.00 from A&I and $33.00 from Case/IH. The tubes are also available. The only problem I ran into with the A&I tubes is the narrowest setting (44") will not work with out trimming 3/8" off the long tie rod. I think it is due to the way they form the taper on the tubes. Most people don"t use the 44" tread, so it isn"t a big issue. Be aware there are two different tubes 7/8" and 1"OD, and the part numbers for the 7/8" OD are different.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Choosin, Mounting and Using a Bush Hog Type Mower - by Francis Robinson. Looking around at my new neighbors, most of whom are city raised and have recently acquired their first mini-farms of five to fifteen acres and also from reading questions ask at various discussion sites on the web it is frighteningly apparent that a great many guys (and a few gals) are learning by trial and error and mostly error how to use a very dangerous piece of farm equipment. It is also very apparent that these folks are getting a lot of very poor and often very dangerous advice fro
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.