Posted by mkirsch on April 09, 2008 at 04:58:00 from (64.80.108.52):
In Reply to: 1939 H Hydraulic Oil? posted by gene bender on April 09, 2008 at 04:32:30:
gene:
The upper ends of the cylinders are probably being used for auxiliary reservoirs. A belly pump doesn't hold enough oil to raise most one-way loaders all the way up without going dry.
This was VERY common with those old "straight arm" loaders with the really long cylinders.
As the loader is raised, oil is pushed out of the tops of the cylinders and into the belly pump through the fill pipe. When the loader is lowered, the excess oil is sucked back into the tops of the cylinders.
Tom B:
You do NOT want the return line on the bottom of the sump. Leave it where it is. Otherwise, the belly pump reservoir will never be full. Here's why:
Because the cylinder shafts are taking up some room inside the tops of the cylinders, there will never be as much oil coming in as going out as you raise the loader. If you raise the loader and refill the reservoir, the loader won't go all the way back down for the same reason.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - The Cletrac General GG and the BF Avery A - A Bit of History - by Mike Ballash. This article is a summary of what I have gathered up from various sources on the Gletrac General GG and the B. F. Avery model A tractors. I am quite sure that most of it is accurate. The General GG was made by the Cleveland Tractor Company (Cletrac) of Cleveland, Ohio. Originally the company was called the Cleveland Motor Plow Company which began in 1912, then the Cleveland Tractor Company (1917) and finally Cletrac.
... [Read Article]
Latest Ad:
Oliver 550 Diesel runs like a watch three point hitch pto engine gone threw about two hundred hours ago nice clean tractor
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.