Hi CenTexFarmall , I hope you're right about it being worth it ! I could have bought a Super M with a loader that ran good yesterday for a couple hundred more than what I will have in parts for this old M .
So far I've gotten everything from CIH . I haven't gotten the axle or final drive bearings yet due to lack of money . I don't think I'll be getting those from CIH though as the neighbor that I'm doing the rebuid at found me bearings for about $50 less per bearing than CIH for the diff and bull pinion . I already have everything needed to complete the transmission . I got the reverse idler and pto pilot bushings from CIH also . Unless you have a ream of the right size you might want to take the reverse idler to a machine shop along with the shaft and have it done by them . That set me back 20 bucks but I got a perfect .003 fit on both ends . I used a brake hone to do the pto pilot bushing and some plumbers mesh to do the pto shaft end . It's a snug fit but there's room for oil in there . Good luck with yours !! ...Randy
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Women and Tractors - More Views From the Farmer's Wife - by Teri Burkholder. The top ten reasons why the judges wouldn't let you participate in the stock antique tractor pull: Hey, this is stock! It came with that V8 in it! That "R" on my tires stands for "really old" not radial! Blue gas? We thought it was a pretty color! What wire hooked to my throttle?
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
