You’re correct that the O-ring for the moveable piston is missing. It should be part # 350667R1. Without the O-ring there is no seal, so the check valve won’t hold pressure. The purpose of the check valve is to prevent the hitch from dropping due to pressure bleed down back in the control valve due to normal wear. It's essentially a safety valve.
I have a single acting check valve on my 340U and a double acting one on the 240U. I rebuilt both valves because the O-rings were badly deteriorated. Your photo looks just like mine did except the O-ring isn’t there. Apparently the earlier models used the single check valve.
The single check valve is supposed to prevent the raised hitch (up pressured)from dropping under load. The double check valve works in both up and down directions. In other words, what it adds is holding the hitch when it is used for down pressure, such as using the hitch to raise the rear wheels off of the ground.
Here’s the blowup of the double acting check valve. I'll see if I can find a schematic of the single valve hookup
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Women and Tractors - More Views From the Farmer's Wife - by Teri Burkholder. The top ten reasons why the judges wouldn't let you participate in the stock antique tractor pull: Hey, this is stock! It came with that V8 in it! That "R" on my tires stands for "really old" not radial! Blue gas? We thought it was a pretty color! What wire hooked to my throttle?
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
