Posted by Hugh MacKay on March 27, 2008 at 09:09:57 from (209.226.247.91):
Keith: Drilled 11/16" holes in my piece of 1" x 2" flat bar got the 5/8" all thread, and the crank pulley is on. I put the fan on with belt, looks to be placed perfect. I didn't use a hydraulic bottle jack either pulling or putting it back. I had a 1" fine thread bolt with 5" of thread with 1"+ hole through center of both puller and pusher. In the past I've had problems using bottle jacks horizontal, had two that did what I wanted at the time, but never jacked again.
Anyhow thanks for all the advice, and a special thanks to Keith. Oh, I did have the pulley hanging about a foot above a convection heater beside me untill it was warm to bare fingers. I think more folks should take a close look at Keith's photos. I'm not a mechanic, just an old farmer, but and old mechanic years ago told me, "Never hammer on a CRANKSHAFT."
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Tractor Profile: Allis-Chalmers Model G - by Staff. The first Allis-Chalmers Model G was produced in 1948 in Gasden, Alabama, and was designed for vegetable gardeners, small farms and landscape businesses. It is a small compact tractor that came with a complete line of implements especially tailored for its unique design. It featured a rear-mounted Continental N62 four-cylinder engine with a 2-3/8 x 3-1/2 inch bore and stroke. The rear-mounted engine provided traction for the rear wheels while at the same time gave the tractor operator a gre
... [Read Article]
Latest Ad:
Oliver 550 Diesel runs like a watch three point hitch pto engine gone threw about two hundred hours ago nice clean tractor
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.