Posted by CenTexFarmall on March 21, 2008 at 13:37:03 from (172.130.89.69):
Well, the Super M transmission sub-project is now officially out of hand! Pulled the top plate just to give it a good cleaning inside and check things. Then the "might as well"'s started. .
Now that I'm in one of these, it's not hard at all to work on. I'm thinking about pulling things apart and completely going through it. I've already got new axle, brake and PTO seals.
When I had the bull pinions in hand I noticed that the bearings had some play in them. Is there a way to check and quantify play in ball bearings? Obviously there has to be some play or they won't roll. But other than obvious mechanical damage what is the best way to check for wear?
Also is there a tolerance or spec for play in the input shaft pilot bearing? I couldn't find anything in the I&T manual. I haven't put a dial indicator on it, but my built in hand indicator feels like it's at about 5 thou.
It's my understanding, too, that the bull gears are symmetrical and can be swapped from side to side so as to run on the less worn side. Is that true? Can the bull pinions similarly be swapped side to side. That should put the teeth face that were reverse to run forward and reduce play, right?
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Choosin, Mounting and Using a Bush Hog Type Mower - by Francis Robinson. Looking around at my new neighbors, most of whom are city raised and have recently acquired their first mini-farms of five to fifteen acres and also from reading questions ask at various discussion sites on the web it is frighteningly apparent that a great many guys (and a few gals) are learning by trial and error and mostly error how to use a very dangerous piece of farm equipment. It is also very apparent that these folks are getting a lot of very poor and often very dangerous advice fro
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.