I've been through similar problems. I adjusted the float by pushing on the viton needle into the seat and it began to stick. Tried some anti-seize on the tip and that didn't help. Finally got a new needle and seat from cnh. Seems like I've seen the all brass needle valves in the kits at TSC. Maybe NAPA has them but I never checked.
They are finicky. They either stick closed or stay open and don't shut off flow.
I had a slight indention in the float where the needle rode all the time. That kept the needle from seating and it flowed all the time and out the carb intake until it started. I took an 1/8" off the float setting which left the float a little high and then it began to work.
Also after finding it lower on gas than I left it every time, I began using the fuel shut off valve and ran it till it quit. The new sediment bowl shut off still allowed a drip out the carb when the needle wouldn't seat so I put a ball valve shut off in there which I now use. So far so good.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Choosin, Mounting and Using a Bush Hog Type Mower - by Francis Robinson. Looking around at my new neighbors, most of whom are city raised and have recently acquired their first mini-farms of five to fifteen acres and also from reading questions ask at various discussion sites on the web it is frighteningly apparent that a great many guys (and a few gals) are learning by trial and error and mostly error how to use a very dangerous piece of farm equipment. It is also very apparent that these folks are getting a lot of very poor and often very dangerous advice fro
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.