Farmall & IHC Tractors Discussion Board |
Re: IH2000 loader fit a 560D?
[ View Follow Ups ] [ Post Followup ] [ Return to Farmall & IHC Tractors Discussion Board ]
Posted by Rod (WY) on March 04, 2000 at 18:52:16 from (199.3.14.82):
In Reply to: IH2000 loader fit a 560D? posted by Mylar on March 04, 2000 at 03:18:17:
Roger is right on the mark. Wish I'd known this two years ago when I bought a 2000 loader for my gas Farmall 656. It was on a 2424 and in excellent shape. Came with front pump, remote valves, and cost me $1700. The frame was too short; had to cut and add about 15 inches to the 4"x4" sub frames where they mount the rear axles; modify the brackets that bolt onto the engine side rails; fabricate a longer support for the control valves; and make new hoses. The loader frame rails are wide and act like a wall that directs engine heat (too much heat) back onto the driver. The loader comes off for the summer. We use the 656 for round baling but it's a tad under-powered for that chore. Rod
Follow Ups:
Home
| Forums
Today's Featured Article -
The Rescue of a Fordson F - by Anthony West. Introduction I live in the UK and have for many years restored Fordson tractors (in the main model N's). I have also restored and shown model F's, E 27N's, Field Marshall Series 2, David Brown Cropmasters and the old rey Fergeson T 20. At one time I had seven restored examples which were shown and used in ploughing matches. As most restorers, I have a number of war stories I can relate on a range of topics that may help other like minded and interested people. Perhaps my first p
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|