Ed, I have mine all apart. Do you have an exploded picture and if so, which number is the piece you're talking about? I'm wondering if you mean #26, the pressure regulator valve seat.
In case it's this, here's what I used-
First off, in case you weren't aware, it's threaded. I used a "drag-link socket" I got at NAPA, about $13. You have to be careful that you can 'lean' on it, so that it doesn't jump out of the slot and nick the borehole.
Once it was unthreaded, my O-ring prevented it's easy removal. By chance, I had a rubber sleeve sitting around from Lord-knows-what, but it fit over an allen wrench, and I stuck it in the center hole on the valve seat, torqued it sideways to 'grab', and pulled it right out.
Another trick (tractorsam? Greg-N-CA?) was to grind a head down on a long bolt to fit into the bore, slip a rubber sleeve like a piece of gas line over the bolt, then run a washer and nut donw, so the rubber spreads out and grabs.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Tractor Profile: Allis-Chalmers Model G - by Staff. The first Allis-Chalmers Model G was produced in 1948 in Gasden, Alabama, and was designed for vegetable gardeners, small farms and landscape businesses. It is a small compact tractor that came with a complete line of implements especially tailored for its unique design. It featured a rear-mounted Continental N62 four-cylinder engine with a 2-3/8 x 3-1/2 inch bore and stroke. The rear-mounted engine provided traction for the rear wheels while at the same time gave the tractor operator a gre
... [Read Article]
Latest Ad:
Oliver 550 Diesel runs like a watch three point hitch pto engine gone threw about two hundred hours ago nice clean tractor
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.