Like Nawlens suggests you'll need close to 25 HP into the generator to get the ~11 KW of electric back out of it. And the H engine is rated at 24 HP if I recall - so it should work except possibly when the genny is loaded to ITS maximum output.
A few considerations:
1 - If you're gonna direct drive the genny it'll need to be a 4 pole gen head and the engine will have to run at 1,800 RPM to get 60 hz. Be certain your engine can deliver full power at 1,800 RPM!
2 - Alternatively you can use a cheaper 2 pole genny and run it at 3,600 RPM for 60 hz - but you'll need to belt drive it from the H engine to get 3,600 RPM.
3 - Unless you are not fussy about generator frequency the RPM droop (difference in RPM no load to full load) on the stock H engine governor may be troublesome.
Good luck - it sounds like a fun and worthwhile project!
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Talk of the Town: Repairin a Gas Tank - by Staff. This interesting discussion is from the Tool Talk Discussion Forum. Remember that safety is your first priority - make sure you know what you are doing before attempting a potentially dangerous activity!
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.