Posted by haas on February 26, 2008 at 07:00:18 from (12.65.36.145):
In Reply to: Cub Clutch posted by scott 1957lboy on February 25, 2008 at 20:34:23:
As Janicholson said, it's the pilot bearing or the splines on the shaft not allowing the disc to slide freely away from the flywheel. Since the tractor sat for a long time, there is likely some crud or rust in the splines and/or the pilot bearing (bushing) is dry or corroded. If the clutch is not slipping, you probably don't need a new clutch disk. However since you are going to have to split the tractor to fix this, you may want to do the clutch replacement anyway. What you describe is common and maybe you need to just live with it if it is not too bad. If you split to fix, make sure the pilot bushing has some grease on it when you reassemble and that the clutch disk slides easily and smoothly on the shaft splines. A little lube or antiseize on the splines is a good idea too. Since there is not much resistance in the Cub transmission when in neutral, the clutch has to be nearly perfect for things to stop when you disengage the clutch. Even then, you may have to wait a bit for thinks to quit turning before you try to engage the gears. If you start the engine with the clutch disengaged but the transmission in gear, you can minimize the problem because the gears will not be turning if the tractor is not moving.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Choosin, Mounting and Using a Bush Hog Type Mower - by Francis Robinson. Looking around at my new neighbors, most of whom are city raised and have recently acquired their first mini-farms of five to fifteen acres and also from reading questions ask at various discussion sites on the web it is frighteningly apparent that a great many guys (and a few gals) are learning by trial and error and mostly error how to use a very dangerous piece of farm equipment. It is also very apparent that these folks are getting a lot of very poor and often very dangerous advice fro
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.