Posted by mkirsch on February 21, 2008 at 10:07:44 from (64.80.108.53):
Pinned in transport position with the land wheel depth adjustment lever horizontal (max lift), I have a good 7" of clearance under the bottoms. The plow sits slightly higher on the right (land wheel) side, maybe an inch. A hydraulic cylinder would probably push the plow up another couple of inches.
The linkage from the cylinder to the furrow wheel isn't bent or broken, and the plow's sitting pretty close to level. I've got to think that this is it on the furrow side.
Should the land side lift higher? There is some damage to the arms on the land axle, and some REALLY BAD welding there.
The lift linkage seems like a pretty weak point on these plows. I was able to easily bend and twist the arms on the land axle back into shape. Definitely going to need some reinforcement.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - The Niagra View Mobile - Powered by a 1959 Ford Tractor - by Mark Massey. In 1959 the Niagara Frontier Transit Inc. of Buffalo, New York designed and built six Viewmobiles for the Niagara Frontier Sightseeing Inc. for use as a sightseeing ride at the Niagara Falls State Park, Niagara Falls, New York, powered by a 1959 Ford 611 Tractor.
... [Read Article]
Latest Ad:
Oliver 550 Diesel runs like a watch three point hitch pto engine gone threw about two hundred hours ago nice clean tractor
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.