|
Farmall & IHC Tractors Discussion Board |
Re: Re: Re: International 574 Parts
[ View Follow Ups ] [ Post Followup ] [ Return to Farmall & IHC Tractors Discussion Board ]
Posted by ltf in nc on March 01, 2000 at 19:59:24 from (206.228.213.235):
In Reply to: Re: Re: International 574 Parts posted by DrCyKosis (to LFT) on March 01, 2000 at 18:38:24:
One was, it has a straight front axle and larger tires. The other one was made in the US. It has a swept back front axle and is lower profiled. The English one has a step to climb aboard and the US has no step. Both have the Robt. Bosch injector pump with the start position on the fuel cutoff control. This is a major asset when cranking in cold weather. My US tractor has 2250 hrs. and I have had it since 50 hrs. Oh yes, forgot to mention, this tractor has the factory ROPS. The English tractor was bought cheap with a Case I H loader mounted to it. The tractor looks good but the engine was poorly maintained by the previous owner. It needs an overhaul. The kits are not cheap. I can overhaul my 200 HP 6 cylinder tractor cheaper. What do you think is a reasonable price on a 574 in good order?
Follow Ups:
Home
| Forums
Today's Featured Article -
Ford N-Series Transmission/Hydraulic Fluid - The Full Story - by Llamas. The transmission fluid in an “N”:-series tractor lubricates the transmission, differential, rear wheel bearings, PTO and hydraulic pump drive, and it also cats as the working fluid for the hydraulic lift. In 9N/2N models, it also lubricates the steering sector and shaft system. The owner’s manual for the 9N and 2N models specified the use of only two fluids. They were STRAIGHT MINERAL OIL SAE 90 (above freezing) and
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co.
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|
