Well that isolates it to the swing cylinders and control valve. From what I understand, sometimes the spool in the control valve will stick in the center which sounds like a good possibility here. I don't know if it is a very common problem. There is also a check valve/ball and spring in the valve that could be weak or getting gunked up and bypassing. You can pull that out to check it. Look for a little bull plug and if it has a ball and spring don't let them fall out and get lost. I checked one that was sticking down, had a little trouble getting the ball to go in and then push it all the way in although it was more of a space problem getting my hands and fingers in there.
Try tapping on the center part of the control valve while trying to make it swing and see if that unsticks the spool.
You can also take your lines loose one at a time from the valve to see if you have flow when you are supposed to. Try this with the boom swung to one side and then later to the other. You would have to move it while you can and then leave it before it warms up.
The IH 3120 does not show up as a valid model on the parts search for international at www.caseih.com or at the case construction website www.casece.com . Find the model # for the hoe on the hoe name plate and try the construction site. If so you can find a schematic and parts list. Also just put backhoe in the model search category and a number of them will come up. You will find a similar one so you have a picture.
Just guessing, if the spool is sticking in the center, maybe it has a weak seal/orings. Works ok with colder heavier hytran, but once the fluid warms up and thins out, then it leaks by.
Let us know what you find out. I know it is a lot of work to tear into these and take them apart and it is nice to know what is broken before you do.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Choosin, Mounting and Using a Bush Hog Type Mower - by Francis Robinson. Looking around at my new neighbors, most of whom are city raised and have recently acquired their first mini-farms of five to fifteen acres and also from reading questions ask at various discussion sites on the web it is frighteningly apparent that a great many guys (and a few gals) are learning by trial and error and mostly error how to use a very dangerous piece of farm equipment. It is also very apparent that these folks are getting a lot of very poor and often very dangerous advice fro
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
