Posted by Steven f/AZ on February 18, 2008 at 07:03:35 from (24.121.155.84):
In Reply to: What Is The Reason? posted by Allan In NE on February 18, 2008 at 02:57:51:
When I put together the live hydrualics on my H, I was told that a suction on the bottom would run all the dirt and sludge through the pump. Even if you put a suction strainer or filter on it, that just means it will plug up sooner.
I took the pump mechanism out and put a plate over the end. I"m not sure how much it holds, but had to add an oil cooler due to my 15 GPM pump and around two or 2 1/2 gallon capacity.
I had them just drill and tap a hole in the side of the casting instead of the front like this diagram shows:
I plumbed the return line into the hole where the control rod used to go in (had the machine shop tap it for 3/4" pipe thread). Top arrow shows return, bottom arrow shows suction.
Here"s my tank:
Someday I plan to add more hydrualic capacity by mounting a reservoir on the axle under my control valves...
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Choosin, Mounting and Using a Bush Hog Type Mower - by Francis Robinson. Looking around at my new neighbors, most of whom are city raised and have recently acquired their first mini-farms of five to fifteen acres and also from reading questions ask at various discussion sites on the web it is frighteningly apparent that a great many guys (and a few gals) are learning by trial and error and mostly error how to use a very dangerous piece of farm equipment. It is also very apparent that these folks are getting a lot of very poor and often very dangerous advice fro
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.