Posted by scott#2 on February 11, 2008 at 15:30:10 from (138.88.69.132):
Just curious about how everyone treats gaskets. I'm in the middle of a Ford diesel (with a jap engine, PUKE) rebuild and the gasket kit for this thing, from the dealer is over $400.00.
Im trying to get away with just buying the majors like head and oil pan, etc., and making the rest.
On head gaskets I use Permatex Hi Tack spray and on oil and water gaskets, hi temp silicone, don't use anything on cork unless it's a oil pan gasket. Cork oil pan gaskets get silicone and get tightened over a period of time as it sets to avoid "squish out". Cork valve coverg go on dry. I might use a light coat of Hi Tack on those thin oil pump cover gaskets after they've been resurfaced, just to make sure it's sealed. Nothing but oil on NPT fittings. I put very few gaskets on dry anymore, just can't seem to stand even a hint of a drop or seepage on a new engine given the time that went into it. I've never tried the lacquer sealer as I've taken a few apart with it and didn't like how it crystalizes and cracks.
The only reason I ask this question is I'm wondering what the latest gasket technology is. Just about every gasket on this engine rebuild appears to have gone on dry, but is D--- tough to get off. I know that head and exaust manifold gaskets sometimes come coated with a heat activated substance that seals up when it reaches operating temperature. On metal head gaskets, I definitly use Hi Tack. On these coated, temp activated, head gaskets, I don't know anymore. On this C-123 engine I just finished, one side said sealer and re-torue required. Is that just sealer on the one side? The other side said nothing, I sprayed both sides with Hi Tack JIC. I'm wondering if the gaskets on this Ford, although they look like plain old gasket paper material to me, might be impregnated with something I don't know about?
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - The Niagra View Mobile - Powered by a 1959 Ford Tractor - by Mark Massey. In 1959 the Niagara Frontier Transit Inc. of Buffalo, New York designed and built six Viewmobiles for the Niagara Frontier Sightseeing Inc. for use as a sightseeing ride at the Niagara Falls State Park, Niagara Falls, New York, powered by a 1959 Ford 611 Tractor.
... [Read Article]
Latest Ad:
Oliver 550 Diesel runs like a watch three point hitch pto engine gone threw about two hundred hours ago nice clean tractor
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
