price would be scrap on up, depending on condition. say for example that to put all new blades and bearings on the disk would be $1200. that would be about your max price if it has all new blades and bearings, but the frame looks worn. a good frame could add quite a bit to the price. the more worn things are, the faster the price goes lower. my dad bought a 14 ft case disk with 40 blades at 9" spacing about 10 yrs ago when we were in a bind for around $500. it had all the outside blades damaged, one of the adjusting screws was broken, and the frame showed signs of previous repairs. we got one season out of it, and a couple bearings and a few blades ended up biting the bullet. We decided to rebuild it this year. found out the blades were 2" worn! bearings and blades approached $1700. The up side to it is that it will be like a new disk once assembled, and shouldn't need much attention for a long time.
hope this helps you get an idea of what you might be getting into
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Choosin, Mounting and Using a Bush Hog Type Mower - by Francis Robinson. Looking around at my new neighbors, most of whom are city raised and have recently acquired their first mini-farms of five to fifteen acres and also from reading questions ask at various discussion sites on the web it is frighteningly apparent that a great many guys (and a few gals) are learning by trial and error and mostly error how to use a very dangerous piece of farm equipment. It is also very apparent that these folks are getting a lot of very poor and often very dangerous advice fro
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.