Posted by Bob M on January 30, 2008 at 06:45:51 from (151.190.254.108):
In Reply to: H shifter questions posted by neblinc on January 30, 2008 at 06:06:53:
Randy - The slots in the 3 shifter rails should all be the same size. (Obviously the .875 shifts the gear(s) that were used the most on your tractor....)
----
You could build-up (weld) then grind the .875 slot to bring it closer to the others. However you'll need to be very careful that the built-up slot is centered with the other 2 when all the rails are re-installed. Otherwise you'll wind up with a "notchy" neutral gate.
I had a similar problem with my Super H. However I simply built-up then ground the tip of the shift lever by trial and error until I got it where it shifted smoothly. The fact the shift rail slot sizes were all slightly different didn't seem to matter.
----
Incidentally that's a slick digital caliper. I bought one just like it to gage/match cutter lengths I sharpen chain saw chains....it works great!
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Choosin, Mounting and Using a Bush Hog Type Mower - by Francis Robinson. Looking around at my new neighbors, most of whom are city raised and have recently acquired their first mini-farms of five to fifteen acres and also from reading questions ask at various discussion sites on the web it is frighteningly apparent that a great many guys (and a few gals) are learning by trial and error and mostly error how to use a very dangerous piece of farm equipment. It is also very apparent that these folks are getting a lot of very poor and often very dangerous advice fro
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.