Posted by Idaho Boy on January 24, 2008 at 17:20:10 from (63.239.240.1):
Gentlemen, I have a SMTA with, I am quite certain, an original IH live hydraulic pump. I am installing a Northern Tool # 2040 (Prince) flow control valve for a power steering motor. The instruction sheet says that there MUST be a relief on the INLET side of that flow control valve. The valve is rated to 3000 psi. Is the IH live pump rated in excess of 3000 psi?
I have purchased a pressure relief valve #2044(Prince), but had planned on installing it downstream of the flow control valve before the the power steering motor. If I install a pressure relief upstream of the flow control valve as instructed and reduce the pressure to 1000 -1200 for the ps motor, the bypass pressure will also be reduced, correct?
Also, how can I tell if my live pump is indeed an IH pump? What kind of pressure does this pump put out if in good condition? I've not put a pressure gauge in line to check the pressure. How much pressure does a remote cylinder need to perform to it's max? Does that vary by cylinder?
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Tractor Profile: Allis-Chalmers Model G - by Staff. The first Allis-Chalmers Model G was produced in 1948 in Gasden, Alabama, and was designed for vegetable gardeners, small farms and landscape businesses. It is a small compact tractor that came with a complete line of implements especially tailored for its unique design. It featured a rear-mounted Continental N62 four-cylinder engine with a 2-3/8 x 3-1/2 inch bore and stroke. The rear-mounted engine provided traction for the rear wheels while at the same time gave the tractor operator a gre
... [Read Article]
Latest Ad:
Oliver 550 Diesel runs like a watch three point hitch pto engine gone threw about two hundred hours ago nice clean tractor
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.