Posted by charles todd on January 18, 2008 at 19:30:08 from (205.242.95.134):
This message is a reply to an archived post by Jim on February 18, 2002 at 14:10:22. The original subject was "What makes a TA slip?".
Mine was slipping on the low side. While changing the clutch and installing a re-surfased flywheel (button clutches are aggressive) I inspected the T/A. My rollers in the sprag had flat spots on them. Installed new rollers, springs, ect. Still had some low slip. I had a machine shop knurl the rollers to increase the O.D. Now the T/A works good in low, but when in direct and you stop in gear with the cluch in, the transmission binds and you have to tease the clutch to slip it into neutral. Eventually I will have to install a rebuilt T/A (bout $600). I do not think I could live with a T/A eliminator kit (5+1 instead of 10+2). Hope this was helpful
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Choosin, Mounting and Using a Bush Hog Type Mower - by Francis Robinson. Looking around at my new neighbors, most of whom are city raised and have recently acquired their first mini-farms of five to fifteen acres and also from reading questions ask at various discussion sites on the web it is frighteningly apparent that a great many guys (and a few gals) are learning by trial and error and mostly error how to use a very dangerous piece of farm equipment. It is also very apparent that these folks are getting a lot of very poor and often very dangerous advice fro
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.