Tom: My brother uses a system for narrow front tractors, using a set of binder truck wheels. He has an axle made up to accept the binder wheels. He places that directly under rear of engine, with adjustable vertical links going up to engine side chanels. He also has diagnol adjustable braces from his binder axle to front bolster. This allows the entire front of the tractor to roll without fear of tipping. He then just places a bottle jack under clutch housing of rear half, lock the brakes, choke rear wheels. By far easier to make the back half stable.
I use a different system, mine works well with wide front, but I have to remove front wheels on a narrow front. I place a hardwood pallet extending from front end to rear of engine. I then use square blocking up to tractor frame making contact in at least 3 places. Using ratchet tie down straps, I anchor the entire front end to the hardwood pallet. I then use a bottle jack under clutch housing and a pallet jack under the pallet. However you do this, always move the front section. The back half is easy to secure, and it will stay put.
Both systems work well, I think I have an advantage with big tractors. I once did a 560 with engine and front end on 1 pallet, torque tube on a second pallet, and each rear wheel filled with chloride and in a standing position on two separate pallets. Definitely works better if you have mulitpule functions going on, the one pallet jack can do all. I have rolled the back half of an articulated Deere away from the front half on a pallet. Quite versitile as your jack is never tied up longer than the actual move. I find you can buy used pallet jacks around $100.-$150. Good solid jacks, very likely slow hydraulics from years of use. I've had the same one for 20 now.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Ford N-Series Transmission/Hydraulic Fluid - The Full Story - by Llamas. The transmission fluid in an “N”:-series tractor lubricates the transmission, differential, rear wheel bearings, PTO and hydraulic pump drive, and it also cats as the working fluid for the hydraulic lift. In 9N/2N models, it also lubricates the steering sector and shaft system. The owner’s manual for the 9N and 2N models specified the use of only two fluids. They were STRAIGHT MINERAL OIL SAE 90 (above freezing) and
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.