Posted by gerardt on January 05, 2008 at 13:38:19 from (86.145.61.192):
A week ago Jim B and El Toro were good enough to explain how I could check to see if the engine is siezed on the 1960"s British-built IH McCormick that was given to me by my neighbour.
To re-cap: It"s been laid up for five years, the steering"s siezed, the tyres are shredded (so I can"t tow it) and the electrics have been eated by something roughly the size of a badger. I enclose a picture for you all to laugh at.
I followed El Toro"s advice and used a car battery to supply power. I shorted across the starter solenoid and succeeded in a) creating a dull clunk and b) melting my jump leads.
I then tried Jim B"s suggestion and used a pipe wrench on the PTO. The hernia should heal given time.
My question now: having established that the engine doesn"t want to turn over do you guys think it"s worth taking it to an engineer and paying to get the thing fixed? Or should I walk away and send it to the scrap yard?
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Ford N-Series Transmission/Hydraulic Fluid - The Full Story - by Llamas. The transmission fluid in an “N”:-series tractor lubricates the transmission, differential, rear wheel bearings, PTO and hydraulic pump drive, and it also cats as the working fluid for the hydraulic lift. In 9N/2N models, it also lubricates the steering sector and shaft system. The owner’s manual for the 9N and 2N models specified the use of only two fluids. They were STRAIGHT MINERAL OIL SAE 90 (above freezing) and
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.