Posted by MJ in the UK on January 03, 2008 at 06:59:43 from (81.154.85.45):
Here in the UK we have had the 3 point hitch since 1936 on the Ferguson Brown tractor and it started to become popular in 1946 with the introduction of the Ferguson T20. The ferguson 3 point was Cat1 and in 1947 Ford put Cat 2 on the Fordson E27N tractor also Nuffield put Cat 2 three point hitch on its Universall tractor introduced in 1948. So as you can see the UK was used to 3 point hitches when they started building the Farmall M at Doncaster in 1949. The 3 point hitch they built for the M in 1950 used the Lift-all belly pump and rams working a cross-shaft to the lift arms. A picture of the linkage can be seen on Mike Farmers excellent shot of a golden Super BMD from a few days ago. The top link was mounted on the tractor with a bracket bolted vertically to the rear of the top cover.It was a very strong lift and i worked one for many years. IH used this lift till 1954 when they fitted an engine driven pump and a rear mounted lift cylinder. MJ
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - The Niagra View Mobile - Powered by a 1959 Ford Tractor - by Mark Massey. In 1959 the Niagara Frontier Transit Inc. of Buffalo, New York designed and built six Viewmobiles for the Niagara Frontier Sightseeing Inc. for use as a sightseeing ride at the Niagara Falls State Park, Niagara Falls, New York, powered by a 1959 Ford 611 Tractor.
... [Read Article]
Latest Ad:
Oliver 550 Diesel runs like a watch three point hitch pto engine gone threw about two hundred hours ago nice clean tractor
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.