Dad always told me it is better to hear the tappets click than not hear them. Steel pushrods expand(Get longer)more than iron engine blocks. That is why they have a hot spec. If pushrods were made from cast iron, I think you could set them at a cold spec. If steel pushrods are set at a spec cold , it would depend on ambiant temp which varies greatly and adds or subtracts to the lenght of the pushrod so it would be tough to come up with a "set" temp for adjusting the valves. The hot spec is so the metal is already expanded at working temp where it will be running at most of the time. Too much gap will not let the valves open all the way and lose power and set too tight will let the exhaust pass by the valve and burn them and also may make it harder to start from loss of compression and from sucking exhaust gas back in when it is supposed to be sucking gas mixture in, less mixture= less power. It is possible to set valves at a cold spec, but you would have to figure ambiant temp, running temp, steel expansion and contraction rates and the engine block expansion and contraction. Much easier to just do it when all expansion is done and not burn valves up and have to pull the head off and replace parts.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Choosin, Mounting and Using a Bush Hog Type Mower - by Francis Robinson. Looking around at my new neighbors, most of whom are city raised and have recently acquired their first mini-farms of five to fifteen acres and also from reading questions ask at various discussion sites on the web it is frighteningly apparent that a great many guys (and a few gals) are learning by trial and error and mostly error how to use a very dangerous piece of farm equipment. It is also very apparent that these folks are getting a lot of very poor and often very dangerous advice fro
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
