Posted by RichH on December 30, 2007 at 15:35:59 from (98.132.227.81):
In Reply to: this odd old 40 A posted by tn terry t on December 29, 2007 at 11:27:55:
In my training as a mechanic back in the 70's, this is how I was told a mag works. First the mag creates its own power to create the spark at the plugs, it has no connection to the battery. When you stop a tractor with a mag you ground out that power and the spark is not created and the tractor stops. The impulse is what creates that power. At a very slow rpm like cranking at the proper time the impulse drive snaps and spins the mags armature a few degrees very quickly to create the electrical power that goes to the coil in the mag and when the properly adjusted points open up it creates the power to make a spark at the spark plug. Most old tractors the mag had adjustable timimg so that when you were cranking and the mag snaped it was when the piston was past top dead center and the engine wouldn't backfire and maybe break your arm or other things, then when the tractor was running the timing was changed back to the preset advance for more power. When the tractor is running the armature is spinning fast enough to create the spark without the impulse snapping. So spinning the engine faster at starting should not be causing the problem, except that if the engine is easily flooded it will flood that much easier. Try starting it first with no choke and after a few seconds if it doesn't start then choke it just a very little and if it still floods you might have other problems like too high gas level in the carb. I have a tractor that I can't pull the choke until it starts and then I have to pull the choke some to keep it running unless it's really cold then I might have to choke it just a little to get it started. I hope this helps. RichH
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Ford N-Series Transmission/Hydraulic Fluid - The Full Story - by Llamas. The transmission fluid in an “N”:-series tractor lubricates the transmission, differential, rear wheel bearings, PTO and hydraulic pump drive, and it also cats as the working fluid for the hydraulic lift. In 9N/2N models, it also lubricates the steering sector and shaft system. The owner’s manual for the 9N and 2N models specified the use of only two fluids. They were STRAIGHT MINERAL OIL SAE 90 (above freezing) and
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
