Posted by Hugh MacKay on December 21, 2007 at 12:36:21 from (209.226.106.23):
In Reply to: IH 656 Engine Swap posted by Clint @ Indiana on December 21, 2007 at 09:16:01:
Clint: Did you ever think of buying a 666D or 686D, and keeping your old 656 for a parts tractor. Probably be less money than what you now propose. I think Cummins can sell you a new 5.9 that will bolt right up. If you go used it will depend on what the Cummins came from.
You could go IH 310, 312, 358 or 360, they will all bolt up at clutch housing. I never used any of these engines long term, however a neighbor had a 666 (I can never remember which is 310 or 312, however his was American engine) and a 886 with 360. He bought a new CaseIH with a 5.9L Cummins. I drove all 3 of them on tillage equipment, and was not impressed with that Cummins. He couldn't have been either, the Cummins was gone in two years. Last I talked with him in 2001, the 666 and 886 were still around. Personally I'd look hard for an IH engine.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Choosin, Mounting and Using a Bush Hog Type Mower - by Francis Robinson. Looking around at my new neighbors, most of whom are city raised and have recently acquired their first mini-farms of five to fifteen acres and also from reading questions ask at various discussion sites on the web it is frighteningly apparent that a great many guys (and a few gals) are learning by trial and error and mostly error how to use a very dangerous piece of farm equipment. It is also very apparent that these folks are getting a lot of very poor and often very dangerous advice fro
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.