Posted by D Slater on December 17, 2007 at 10:38:43 from (71.164.40.188):
In Reply to: SH distributor posted by aaachris on December 17, 2007 at 08:14:21:
If the movement is clockwise and counter clockwise it may be normal, little to no side to side play would be good. I think the shaft listed on this site isn't the one you need for the distributor which I call the rotor shaft. Its not hard to check your unit before deciding what to do. After removing unit at the 2 clamp bolts( note engine and dist position for reinstalling) remove everything down including points. Remove stud with insulator that points and coil wire attaches to. Remove the 2 screws that cap clips are attached to and 1 other screw half way between those 2. lift out point mounting plate. Next there's a weight guard a thin formed metal piece with 2 screws to remove. Warning if screws to long for condenser or point contact mounting were installed or installed in future they will wear metal deform or junk this guard. Remove 2 advance springs and lift out the cam piece. There can be play between it and rotor shaft,check. If not missing there would be a felt in the hollow cam shaft, its suposed to be oiled every so often. Lot don't get lubed.Now you can check the rotor shaft to dist. housing play. To remove rotor shaft from housing the gear on end of shaft has a pin to remove, then shaft can be removed to determine what needs repaired. Thin thrust washers are located at top and bottom of shaft. O ring seal is in drive end of housing. Common problems, weight pins loose on rotor, weight holes elongated, advance hole worn oversize. Not as common, gear wear or loose where pined to shaft, cam lobes bad.After repairs don't forget to grease where plug is in dist housing once in a while. May have forgot something, if needed ask.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Choosin, Mounting and Using a Bush Hog Type Mower - by Francis Robinson. Looking around at my new neighbors, most of whom are city raised and have recently acquired their first mini-farms of five to fifteen acres and also from reading questions ask at various discussion sites on the web it is frighteningly apparent that a great many guys (and a few gals) are learning by trial and error and mostly error how to use a very dangerous piece of farm equipment. It is also very apparent that these folks are getting a lot of very poor and often very dangerous advice fro
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
