Posted by CTjohn on December 10, 2007 at 07:30:29 from (63.165.62.3):
I am investigating an early 50’s Super C clutch noise. Upon take down the clutch components all looked good and only slightly worn as they was replaced 3 years ago. The flywheel step was confirmed as 1.188” as provided by earlier posters (thanks!).
The noise was the clutch rod (inside the torque tube) which is attached to the yoke below the release bearing hitting the adjustment bolts for the pressure plate when the clutch is engaged. The clutch does not slip. No excessive play in yoke or yoke shaft. Some play at clutch pedal to housing pivot point which should not affect this problem.
It would seem that the pressure plate fingers should be extended further outward such that the release bearing contact and clutch disengagement would occur prior to the clutch rod contact with the pressure plate.
I have read the pressure plate fingers can be adjusted (27/32”). If clutch is assembled into the flywheel with pressure plate installed how this measurement can be easily made. The distance as I understand it is from the fingers to the bottom surface of the pressure plate when installed.
When installed you can not measure to the bottom surface of the pressure plate. Unless you measure the thickness of the clutch disc and then find/make a “dummy” piece the same thickness (like ¼ plywood disc) and substitute this for the clutch disc for measurement. I would like to check this dimension.
Do I have the correct parts installed?? How do I confirm? 9” Rockford clutch plates believe had different springs could the springs be not correct?
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Ford N-Series Transmission/Hydraulic Fluid - The Full Story - by Llamas. The transmission fluid in an “N”:-series tractor lubricates the transmission, differential, rear wheel bearings, PTO and hydraulic pump drive, and it also cats as the working fluid for the hydraulic lift. In 9N/2N models, it also lubricates the steering sector and shaft system. The owner’s manual for the 9N and 2N models specified the use of only two fluids. They were STRAIGHT MINERAL OIL SAE 90 (above freezing) and
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
