Posted by riverbend on December 09, 2007 at 18:10:58 from (208.160.33.209):
I have been digging into the rear end on my H lately. What looked like a blown grease seal behind the brakes has turned into a relatively major tear down (for this tractor).
The problem was actually caused by a broken differential case. besides the case, the inner and outer bearings in the right side bull pinion carrier were bad. The inner axle bearing on that side was missing a few balls and about half of the retainer. The bull pinion on the left side has a couple chipped teeth. And, oh yeah, the grease seals on the right side brake were shot too. Other than that, it worked fine.
I think that the differential probably broke a couple years ago. At that time, the seal on the right side brake was leaking and since the outer bearing looked good, I just put new seals in, cleaned up the brake band, and let it go at that. In retrospect, that's probably when the bearing spigot sheared off the differential.
In the mean time, he has been busy earning his keep plowing, disking, planting, plowing snow, etc. What ever needed doing, the H was getting it done.
On taking the rear end apart, there is a thick layer of metallic mud in the bottom of the case by the drain plug and in the axle carriers. I doubt that any modern tractor would see another day in the field with that much metal circulating in the transaxle.
It is no wonder why people are so attached to these tractors. 68 years old and going back into the field in the spring. I'll probably have to quit doing wheel stands 'though.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Choosin, Mounting and Using a Bush Hog Type Mower - by Francis Robinson. Looking around at my new neighbors, most of whom are city raised and have recently acquired their first mini-farms of five to fifteen acres and also from reading questions ask at various discussion sites on the web it is frighteningly apparent that a great many guys (and a few gals) are learning by trial and error and mostly error how to use a very dangerous piece of farm equipment. It is also very apparent that these folks are getting a lot of very poor and often very dangerous advice fro
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
