Migraine: I think your Continental diesel has a manifold heater. I don't know much about these but I notice George KY in discussion telling someone about the heater they didn't know existed. This manifold heater works similar to glow plugs other than heating the intake manifold.
That magnetic heater, Michael speaks of works well. My brother has one large enough to cup right around oil pan. Once you have the oil hot, you know where your excess heat is going. I've really never seen anything more effective than hot crankcase oil. I can remember a sawmill operator back in the 50s, had a diesel forklift. Every night he drained oil, put it in a heated building. Next morning he warmed it on a camp stove. I've quite often built fires under oil pans on diesels. You have to be sure you have no oil or fuel leaks. I don't like this method but hot crankcase oil does work. The fires I used were barbeque charcoal in cast iron fry pan. I put them right under oil pan. I did this with my 6.2 diesel pickup once at -40. By the time the charcoal burned out, the diesel started and the heater generated heat within 45 seconds. I just throw this in to point out the value of warm or hot oil. I don't recommend the daily use of charcoal fires under the oil pan.
The other great one is the circulating coolant heater, with an element in an external tank. These lend themselves well on some engines, ideally they should have a block drain about mid engine, then a port into water jacket of head again about mid way along engine. The coolant drains into heater from bottom of block, is heated then rises to the head. This works same as thermosyphon, thus it is best if both ports are on same side with heater clamped between the two, in a vertical position.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Picking Corn - by Rick Nikolich. It was the day before Christmas shutdown at work and I asked our lead engineering expert Scott Andrzejewski what he was going to do over the holidays. He said that he had some corn that he still needed to pick with an antique one-row New Idea corn picker. Scott has a nice farm about an hour north of Lansing in St. Johns, MI. He wanted to get the rest of his corn in by the next day (Christmas Eve). We had about an inch of new snow on the ground and single digit temperatures. So in the bac
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
