Becarefull forcing it off. I have seen several get cracked at the step down for the belt pulley. Those threaded rod looking things are studs and are removed by putting on a nut and tightening it down, the stud will pull up and out. Belt pulley should be off when removing the cover. Also remember the cover is one big chunk of cast iron and it has the shifter forks going down to the trans gears so be careful to lift it as straight as possible and from the left side first. You will want to have help for this! I would do it by hand so nothing gets forced. I used a stiff bladed putty knife to get it started and went around the sides carefully with several screw drivers and gently pried it up. Mine was stuck pretty good also but it weighs so much it fooled me to think it was stuck worse than it was. Are you the guy on the north side of Indy? I will be on N College ave near 86th for Thanksgiving and could pop by if you need. Bad day for messing with tractors, but I don"t get up there that much and could spare a few minutes. My family has been in the area since 1840s and other relations since 1816. Good to know a farmall is still around there! There used to be a bunch of them up there!
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Choosin, Mounting and Using a Bush Hog Type Mower - by Francis Robinson. Looking around at my new neighbors, most of whom are city raised and have recently acquired their first mini-farms of five to fifteen acres and also from reading questions ask at various discussion sites on the web it is frighteningly apparent that a great many guys (and a few gals) are learning by trial and error and mostly error how to use a very dangerous piece of farm equipment. It is also very apparent that these folks are getting a lot of very poor and often very dangerous advice fro
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.