Mike Here is is the easy way to assure you are getting the valves adjusted correctly::::(this trick works for every four cycle engine with any number of cylinders. It also positions the valves at known positions that are on the base circle of the cam, and not in an unknown position.
They are arranged From front to back: #1Exhaust, Intake,-----#2Intake, Exhaust,----- #3Exhaust, Intake,----- #4Intake, Exhaust.
Make a chart of the valves EI-IE-EI-IE on paper to take with to the engine.
When the exhaust valve just begins to open, adjust the intake on that cylinder. When the intake just closes, adjust the exhaust on that cylinder.
Make sure you treat one cylinder at a time (lay rags over the other valves on the other cylinder's so there is no error)
I think they are set at .020" cold.
Crank it by hand with the plugs out, it makes it easy.
Before starting, do the oilcan trick I described in the last post. and do not oil the valves, they are fine!!! JimN
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Choosin, Mounting and Using a Bush Hog Type Mower - by Francis Robinson. Looking around at my new neighbors, most of whom are city raised and have recently acquired their first mini-farms of five to fifteen acres and also from reading questions ask at various discussion sites on the web it is frighteningly apparent that a great many guys (and a few gals) are learning by trial and error and mostly error how to use a very dangerous piece of farm equipment. It is also very apparent that these folks are getting a lot of very poor and often very dangerous advice fro
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.