If you decide to pull the valve cover off, take the nuts loose and let it sit a few days, then gently bump the valve cover sideways slightly and slowly start to raise it up. Look closely that the gasket doesn"t stick to the head in one place and to the cover in another. Unless someone "blue glued" it or used some kind of sealant you might be able to reuse the gasket for a while. If it cracks though it is done for good. Be ready to see all kinds of crud in there, but if you don"t disturb it it will stay put or if you clean it up in there , plug any holes that will let the crud find its way to the oil pan like around the pushrods or any oil drain back holes. The valve cover inside can be cleaned since it will be off anyway. Like the others have said it can"t hurt to spray or squirt some lube on the valve stems in side the springs and on the notched part of the rocker arms. It is ok to let some oil go down the pushrods holes also as some will find its way to the cam. How close is the "big fire it up day"?
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Choosin, Mounting and Using a Bush Hog Type Mower - by Francis Robinson. Looking around at my new neighbors, most of whom are city raised and have recently acquired their first mini-farms of five to fifteen acres and also from reading questions ask at various discussion sites on the web it is frighteningly apparent that a great many guys (and a few gals) are learning by trial and error and mostly error how to use a very dangerous piece of farm equipment. It is also very apparent that these folks are getting a lot of very poor and often very dangerous advice fro
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.