Welcome! Please use the navigational links to explore our website.
PartsASAP LogoCompany Logo (800) 853-2651

Shop Now

   Allis Chalmers Case Farmall IH Ford 8N,9N,2N Ford
   Ferguson John Deere Massey Ferguson Minn. Moline Oliver
 
Marketplace
Classified Ads
Photo Ads
Tractor Parts
Salvage

Community
Discussion Forums
Project Journals
Your Stories
Events Calendar
Hauling Schedule

Galleries
Tractor Photos
Implement Photos
Vintage Photos
Help Identify
Parts & Pieces
Stuck & Troubled
Vintage Ads
Community Album
Photo Ad Archives

Research & Info
Articles
Tractor Registry
Tip of the Day
Safety Cartoons
Tractor Values
Serial Numbers
Tune-Up Guide
Paint Codes
List Prices
Production Nbrs
Tune-Up Specs
Torque Values
3-Point Specs
Glossary

Miscellaneous
Tractor Games
Just For Kids
Virtual Show
Museum Guide
Memorial Page
Feedback Form

Yesterday's Tractors Facebook Page

  
Farmall & IHC Tractors Discussion Board

Re: how to charge 6 v battery


[ Expand ] [ View Replies ] [ Add a Reply ] [ Return to Forum ]

Posted by Hugh MacKay on November 09, 2007 at 13:56:28 from (209.226.247.179):

In Reply to: Re: how to charge 6 v battery posted by John T on November 09, 2007 at 10:18:30:

John: I think what saved me, car was parked in a straight line with tractor, car battery was on the right, and I was on left ahead of rear wheel. Between the tractor wheel, seat with battery box under it and fender, all shielded me quite well. I had gone direct to starter for my boost thus the tractor battery box was closed. I was very, very lucky.

Tractor didn't suffer any ill effects of the blast. I've done quite a bit of blasting with dynamite over the years, even set loads as large as 48-1" x 10" sticks and the blast wasn't any worse than that battery. I was 50'from that dynamite blast but also had better shelter.

Now the most messy explosion I ever had was dynamiting a frozen manure pile. First one didn't work, so I loaded a bit heavier, center of that manure pile wasn't frozen. I had the most speckled barn in the county. Folks used to stop by, ask who did the art work. I got into dynamiting quite young, my dad and I wanted to reclaim some flood plain. I had taken courses on open ditching with dynamite at ag college. We'd load as much as 2,000' at a time, and would cut a 5' deep, V shaped ditch. This was flood plain one had to be careful crossing with horses in the 1940s. By 1960 we were crossing it with big tractors and trucks. This product was called ditching dynamite, you made a hole roughly 2' deep with a bar, cut the dynamite length according to how hard ground was, holes were 6" apart, used one blasting cap on the first hole and the rest was chain reaction. It was about 25% of the cost of heavy equipment and no getting machines bogged.


Replies:




Add a Reply

:
:
:

:

:

:

:

:

:

: If you check this box, email will be sent to you whenever someone replies to this message. Your email address must be entered above to receive notification. This notification will be cancelled automatically after 2 weeks.


TRACTOR PARTS TRACTOR MANUALS
We sell tractor parts!  We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]

Home  |  Forums


Today's Featured Article - Choosin, Mounting and Using a Bush Hog Type Mower - by Francis Robinson. Looking around at my new neighbors, most of whom are city raised and have recently acquired their first mini-farms of five to fifteen acres and also from reading questions ask at various discussion sites on the web it is frighteningly apparent that a great many guys (and a few gals) are learning by trial and error and mostly error how to use a very dangerous piece of farm equipment. It is also very apparent that these folks are getting a lot of very poor and often very dangerous advice fro ... [Read Article]

Latest Ad: Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request [More Ads]

Copyright © 1997-2024 Yesterday's Tractor Co.

All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy

TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.

Yesterday's Tractors - Antique Tractor Headquarters

Website Accessibility Policy