Posted by Wisconsin_Joe on November 06, 2007 at 06:10:06 from (72.171.0.143):
I have been trying to track down a current drain on my electrical system. I used Jim N"s easy to follow troubleshooting that I saw on another post. The one where you disconnect the positive (+) battery terminal and hookup your meter in between the post and the terminal. It said if you read 12 volts or more something in the system drawing current. Next you go through step by step to narrow it down starting in my case at the alternator. When you find the offender the volts should drop to zero. When I hook the meter up as mentioned I get something like 12.6 volts draw. If I disconnect the main batt alternator wire it drops to about 3 volts. I suspect my alternator is bad by my above findings. I am just wondering why I still have 3 volts drawing. This happens even when I go through the rest of the troubleshooting test points. Is my push starter switch bad as well? Am I missing something?
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Choosin, Mounting and Using a Bush Hog Type Mower - by Francis Robinson. Looking around at my new neighbors, most of whom are city raised and have recently acquired their first mini-farms of five to fifteen acres and also from reading questions ask at various discussion sites on the web it is frighteningly apparent that a great many guys (and a few gals) are learning by trial and error and mostly error how to use a very dangerous piece of farm equipment. It is also very apparent that these folks are getting a lot of very poor and often very dangerous advice fro
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.