Re: F-12 govener

Posted by Doug N on November 03, 2007 at 12:21:20 from (205.188.116.73):

In Reply to: F-12 govener posted by oldiron29 on November 03, 2007 at 04:27:28:

Old Iron, The main shaft will have some play, but yes the bearing is replaceable. If you look in the block where you took out the governor you'll see a brass bushing just above the cam where the shaft goes into. Once it's in that bushing there should be no play. The bearing is 2.046" OD and .982" ID. Part number is IHC ST-208. You'll need to press it apart. I have mine apart now for bearings.

Now as far as the other piece having play. You shouldn't have hardly any at all. I have no play at all on mine. when it is on the shaft it is snug, but not so snug that it doesn't move. That piece is brass, and it goes between the weights and the thrust washer to the fork. Some play won't hurt, but alot could cause binding and be stuck wide open. If is too terribly sloppy and can't get one thru Case IH, A machine shop can easily make one out of brass. It's a very simple piece. Just make sure you take them the gov shaft so they get the ID of the bushing right.

Doug N

Replies:

Add a Reply Name: E-Mail: Subject: Comments: Optional Link URL: Link Title: Optional Image URL: Optional Video Title: Optional Video URL: Email Notification: If you check this box, email will be sent to you whenever someone replies to this message. Your email address must be entered above to receive notification. This notification will be cancelled automatically after 2 weeks.

TRACTOR PARTS	TRACTOR MANUALS

We sell tractor parts!  We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]