Yes you can as long as ya have steering and brakes . Myself i like to pull the valve cover and make sure that both intake and exhaust on # 1 are closed and that i have the timing window on the bell houseing open and set the pointer back in the open window and replace the two 1/4 inchs bolts ans snug down and set the timing at 18 degrees before TDC. then ya remove the ft cover plate on the ft. of the engine and re move the nut clean all around the pump and blow it off real good then start unhooken the lines and linkage . Don't care how ya seal up the lines just as long as they are kept clean . . Some say my way is to time consuming Maybe so but i have never had one that i had to pull the pump back off and turn it 180 to get it to fire . And while i have the valve cover off it is a real good time to run the overhead.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Talk of the Town: Repairin a Gas Tank - by Staff. This interesting discussion is from the Tool Talk Discussion Forum. Remember that safety is your first priority - make sure you know what you are doing before attempting a potentially dangerous activity!
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
