Like they say a picture is worth a thousand words so take a look at the Gempler's website for that. Safety first!
The only thing I do different is too use a wood splitting wedge to bust the beads. Just set the tappered end in the rubber to steel edge and lightly tap once then move the wedge 3" and repeat 4times and the bead will easy pop, then do the inside bead the same way.
On a stubbern bead use a small amount of 50% dish soap/water mix. Do not beat on the hammer harder as it won't help. You may have to move more than 4 times or rework the area if you don't hold the wedge in the right spot, but doubtful.
Dulled crow bars also work well for tire irons. Any thing to do with rubber needs a smoothed rolled edge.
The tubes like corn starch as a slipper agent. I always fill the tire up to about 20psi, after the bead is set, then let it blow down then refill for set pressure. This allows the tube to unfold inside the tire.
Here they want $150/tire for a service call. It takes me less than 1hr to remove and install a tire and tube, and I'm crippled up.
Besure and read about tire repairing safety while your searching for the info.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Tractor Profile: Allis-Chalmers Model G - by Staff. The first Allis-Chalmers Model G was produced in 1948 in Gasden, Alabama, and was designed for vegetable gardeners, small farms and landscape businesses. It is a small compact tractor that came with a complete line of implements especially tailored for its unique design. It featured a rear-mounted Continental N62 four-cylinder engine with a 2-3/8 x 3-1/2 inch bore and stroke. The rear-mounted engine provided traction for the rear wheels while at the same time gave the tractor operator a gre
... [Read Article]
Latest Ad:
Oliver 550 Diesel runs like a watch three point hitch pto engine gone threw about two hundred hours ago nice clean tractor
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
