Posted by HENRY E NC on October 24, 2007 at 21:28:23 from (216.119.7.19):
In Reply to: Re: Driving class posted by glennster on October 24, 2007 at 10:20:48:
I havent done a hayride for 50 years but i HAVE DONE SOME PARADES and I always recommend starting in 2nd or 3rd shifting to 4th. Less jerky starts and easier to keep up. 1st gear is a waste as it is strictly for power. When I teach my grandchildren to drive the M I always start them in 2nd and tell them to slip the clutch,. Also for shifting on the go, I can do it from 4th to 5th very well but below that I grind a small amount. Be sure to pause in neutral for a short time. The speeds on the H are 1, 2 5/8 mph, 2, 3 mph, 3, 41/4 mph 4,,5 3/8 5, 15 5/8 with 10-38 tires. Larger tires will increase the speed proportionally. My M does 18.0 with 15.5 tires but book calls for 15 5/8 with 12.8 tires.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Choosin, Mounting and Using a Bush Hog Type Mower - by Francis Robinson. Looking around at my new neighbors, most of whom are city raised and have recently acquired their first mini-farms of five to fifteen acres and also from reading questions ask at various discussion sites on the web it is frighteningly apparent that a great many guys (and a few gals) are learning by trial and error and mostly error how to use a very dangerous piece of farm equipment. It is also very apparent that these folks are getting a lot of very poor and often very dangerous advice fro
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.