D Raymond: If you think starter lockup is the cause, pull the starter, have a look at the teeth on starter drive as well on the flywheel ring gear. Let us know what you see, condition of those gears. If this only happens once in 45-50 starts very likely the starter motor itself is in good condition.
Next time it happens, try loosening the starter mounting bolts until you can move back of starter 1/4" sideways. Then try the starter with it loose, if it works you may run it for years that way. Another way to loosen a locked starter if you are on level ground, is place the tractor in high gear and rock it one way then the other on a rear wheel. Often doing it that way you will hear a click when starter unlocks. Still another is place it in 5th and give it a tug backwards with another vehicle.
I've run them that way for years, probably wont get much worse for some time. Tow starting will do damage when the starter is locked, in fact you can bend the starter shaft. Shame to do that if the motor portion of the starter is in good working order.
Probably your going find a bad spot on the flywheel ring gear. Changing that ring gear requires splitting the tractor. Years ago we often ran them that way until we had other reasons to split the tractor, ie engine rebuild, clutch replacment, etc. I know this may be annoying however you may split the tractor, find you have a clutch and presure plate one year away from replacing. Personally, unless it gets worse, I'd wait until major rebuild time for ring gear. Called, killing two birds with one stone.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Choosin, Mounting and Using a Bush Hog Type Mower - by Francis Robinson. Looking around at my new neighbors, most of whom are city raised and have recently acquired their first mini-farms of five to fifteen acres and also from reading questions ask at various discussion sites on the web it is frighteningly apparent that a great many guys (and a few gals) are learning by trial and error and mostly error how to use a very dangerous piece of farm equipment. It is also very apparent that these folks are getting a lot of very poor and often very dangerous advice fro
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
