Posted by bushmaster on October 16, 2007 at 13:06:04 from (64.252.76.144):
In Reply to: ih3414 posted by bushmaster on October 14, 2007 at 16:54:04:
thanks. looking at one and it cant be started the guy lifted something to heavy andpulled both bucket tilt cylinder shafts out of the tubes guy says if he starts it hyd fluid will blow out all over.guy tells me everthing works fine otherwise.he is asking 2000 for it but im a little worried about the rest of it. i see that a hyd pump and deisel injector pump go for around a thousand dollers each and trans and rear end parts are scarce and very expensive. was looking for some experienced sugestions if i should buy and hope for the best or walk away. thanks again
oh whats the weight of this machine with loader and backhoe? i see many diffrent #s 10,000 lbs-8000 lbs.. any 1 know?
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Tractor Profile: Allis-Chalmers Model G - by Staff. The first Allis-Chalmers Model G was produced in 1948 in Gasden, Alabama, and was designed for vegetable gardeners, small farms and landscape businesses. It is a small compact tractor that came with a complete line of implements especially tailored for its unique design. It featured a rear-mounted Continental N62 four-cylinder engine with a 2-3/8 x 3-1/2 inch bore and stroke. The rear-mounted engine provided traction for the rear wheels while at the same time gave the tractor operator a gre
... [Read Article]
Latest Ad:
Oliver 550 Diesel runs like a watch three point hitch pto engine gone threw about two hundred hours ago nice clean tractor
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
